Description
Emballeuse a palette Wulftec avec convoyeur
Modèle WCRT-200 ICTS
230 volts 3 phases avec transformateur
PRODUCTION – Up to 65 loads per hr., based on load
configuration and machine options.
Higher speeds can be obtained with different
options
LOAD WEIGHT – 4,000 lbs.
APPROX SHIPPING WEIGHT – 4,463 lbs.
LOAD SIZE – Min. – 36″W x 36″L x 10″H – Max. – 48″W x 48″L x 80″H
ELECTRICAL REQUIREMENTS – 230/3/60, 15 AMP
(other voltage available upon request) **
PNEUMATIC REQ. – 3 CFM @ 80 PSI comes with FR
(Filter, Regulator)
MACHINE DIMENSIONS
126˝W x 150”L x 140 ”H *
* Overall dimensions of the system
in operation.
CONTROLS – Allen Bradley SLC 5/03 PLC – 24V control system – Current overload protection with AC drive – Nema 12 control cabinet with quick disconnect – Auto-height sensing photoeye with on/off mode – Power on/off lockable switch and indicator light – 1 E-STOP mushroom type push button on the control panel and one
in the wrapping zone – Allen Bradley Touch Panel – Variable rotary arm speed (17 RPM) – Separate up and down carriage speeds – Separate top and bottom wrap selections (0-9) – Positive arm alignment – Film force to load control – Double brush dust tight slip ring – Emergency stop sensor for arm path obstruction – Dynamic braking system for rotary arm with AC drive – Alarm beacon light – Manual clamp jog – Manual function for rotation fwd/rev., carriage up/down – All conveyor fwd/rev. – Intuitive alarm diagnostic on touch screen – Reset function – Air pressure switch
FILM DELIVERY SYSTEM – 20″ NO-THREAD® Powered Pre-Stretch Carriage – 1/2 HP AC motor with Allen Bradley variable frequency drive – 50-300% prestretch ratio (preset to customer spec, Std 200%) – Electronic film tension control with analog sensor – Lexan roller cover – Film force release for easy pull at start and end of cycle – Angled carriage to wrap approximately 2” from conveyor level
FILM CARRIAGE DRIVE – 3/4 HP AC with Allen Bradley variable frequency drive – Two #50 chain carriage lifts for safety – Dual ½” CRS ways with UHMW-PE carriage glides – Dual steel boom
ROTARY ARM – All structural steel construction – (4) 6” X 6” floor mounting legs
ILM TAIL TREATMENT – Automatic film clamping – Pulsed controlled cutter – Film alignment arm – Brush-on film tail treatment, Heat Seal available **
ROTARY ARM DRIVE – 25” Ring Gear Bearing drive/support – Automated Lube Station. – Max. 17 RPM variable speed – 1 HP AC motor with Allen Bradley variable frequency drive – Electronic soft start/stop – Positive arm alignment controlled by proximity sensor – Protection guard over the ring gear bearing – Dynamic braking system for rotary arm with AC drive
CONVEYOR – Powered process conveyor, 11’-6” long – Standard: Pass height 18”, other pass heights available ** – 3/16″ wall cold rolled electric welded steel rollers – 2 1/2″ dia. rollers on 3″ centers – 52” BFR (between frame rails) – All rollers driven via #40 chain – 3/4 HP AC motor with Allen Bradley variable frequency drive – Heavy duty design – Heavy duty cast iron flange mounted bearings – Up to 35 feet per minute, other speeds available ** – Additional conveyors and other types available upon request. **
#3770
